S3C2410_GPB1改为S3C2410_GPB(1), 另一个帖中有。

支持一下，mark！

为什么把GPE11和GPE12连接后，编译测试程序spidev_test.c结果全是FF，与没有连接的结果一样，怎么回事啊，连接与否没有起作用，请指教

mark一下备用。

怎样改static struct s3c2410_spi_info s3c2410_spi0_platdata结构体使得有两个片选信号S3C2410_GPB1,S3C2410_GPB0
static struct spi_board_info s3c2410_spi0_board[] = {
        [0] = {
                 .modalias = "spidev",
                .bus_num        = 0,  
                .chip_select        = 0,
                .irq = IRQ_EINT9,
                .max_speed_hz         = 500*1000,
                .mode = 0,
        },
        [1] = {
                 .modalias = "spidev",
                .bus_num        = 0,  
                .chip_select        = 1,
                .irq = IRQ_EINT9,
                .max_speed_hz         = 500*1000,
                .mode = 1,
        },

};

static struct s3c2410_spi_info s3c2410_spi0_platdata = {
        .pin_cs = S3C2410_GPB1,
        .num_cs = 2,
        .bus_num = 0,
};